Maintenance of the solenoid valve: The cooling of the solenoid valve, the spool of the solenoid valve has been invalid, Wholesale beer brewing equipment the valve core sealing is invalid, and the damage of the electromagnetic coil may result in the failure of the solenoid valve.

Power-on reducer injection 46 # machine oil, tu on the motor cover with hand to tu the blade check No card-free phenomenon, mixing paddle has no wiper wall, cleaning the dirt in the kettle, can be tued on. It should be installed on a sturdy, flat workbench, the work station is highly determined according to the usage, and the equipment and the workbensors should have a certain space (& ge; 360cm) so that Installation and post-maintenance!

Tu off the solenoid valve, and the exit has a cooling water leak, and the valve core seal fails or fragment blockage the spray. A high quality winemaker is indispensable, in which the most important thing in the equipment is the fermenter, it can be said to be the key to wine. Trouble judgment: The circulating pump is operating normally, the cycle line is normal, and the temperature drop is not only the greatest reason. With the spread of German beer culture, it has gradually become a very important part of our daily lives.

Bearing replacement: 1 - 2 years after use, bearing noise is increased, or the agitating shaft is significantly swing to replace the bearing. During the installation process, the air dispenser should be re-filled, replace the fill hole in time, such as replacing the bottom valve, replace the bottom valve gasket. The transmission shaft is required to be vertical at the time of installation, no verticality (inclination) is not greater than 1/1000 ~ 3. Depending on the water injection switch, the water injection switch indicator is on, the end of the solenoid valve has no magnetic, no cooling water discharge, and the coil is broken.

امتیاز بدهید :